Issue 1.2
UNIVERGE SV9100
5 - 130
Installing DT Series Digital and IP Multiline Terminals
q
Charge the battery pack provided with or identified for use with this product only
in accordance with the instructions and limitations specified in the instruction
manual provided for this product.
q
Observe proper polarity orientation between the battery pack and battery
charger.
q
Do not
dispose of the battery pack in a fire, the cell may explode.
q
Do not
place the batteries in your regular trash. The nickel-metal hydride
battery must be collected, recycled, or disposed of in an environmentally sound
manner. Contact your local waste management officials for other information
regarding the environmentally sound collection, recycling and disposal of the
battery contained in this product.
10.3 Important Safety Instructions
When using the telephone equipment, basic safety precautions should always be
followed to reduce the risk of fire, electrical shock, and injury to persons, including the
following:
q
Read and understand all instructions.
q
Follow all warnings and instructions marked on the product.
q
Unplug this product from the wall outlet before cleaning.
Do not
used liquid
cleaners or aerosol cleaners. Use a dry cloth for cleaning.
q
Do not
use this product near water; for example, near a sink or in a wet area.
q
Do not
place this product on an unstable cart, stand, or table. The telephone
can fall, causing serious damage to the unit.
q
To protect the product from overheating, do not block or cover any slots or
openings in the base unit. This product should never be placed near or over a
radiator or heat register. This product should not be placed in a built-in
installation unless the proper ventilation is provided.
q
This product should be operated only from the type of power source indicated
on the marking label.
q
Do not
allow anything to rest on the power cord. Do not locate this product
where the cord will be damaged by people walking on it.
q
Do not
overload wall outlets and extension cords, as this can result in the risk of
fire or electrical shock.
q
Never push objects of any kind into this product through the base unit slots, as
they may touch dangerous voltage points or short out parts that could result in a
risk of fire or electrical shock. Never spill liquid of any kind on the product.
q
To reduce the risk of electric shock, do not disassemble this product. Contact
qualified service personnel when some service or repair work is required.
Opening or removing covers may expose you to dangerous voltages or other
Summary of Contents for Univerge SV9100
