UNIVERGE SV9100
Issue 1.2
System Hardware Manual
6 - 31
When using center feed, set the SW1 switch located on the back of
the adapter as follows:
11.2.2
Installation
1.
Set the SW1 switch on the ILPA-R adapter to the correct
setting for the ethernet switch to which it is to be connected.
2.
Set the switch setting on the NEC IPhone or IP adapter to the
correct position.
Figure 6-21 In-Line Power Adapter Switch Settings
Center Feed Hub System
SW1 Setting
IEEE802.3af STD System
1
Cisco Discovery Protocol System
1
NEC BlueFire 200/24 Switch
2
Center Feed Hub System
SW1 Setting
IEEE802.3af STD System
1
Cisco Discovery Protocol System
1
NEC BlueFire 200/24 Switch
2
IPhone (SW2) or IP Adapter (SW1)
SW Setting
NEC Power Patch Panel
(12 port NEC SN1604 PWRMS,
24 port NEC BlueFire 200/24)
8SHUBU Blade
1
Cisco Catalyst Power Patch Panel
Cisco Catalyst PRW Series
2
Summary of Contents for Univerge SV9100
