Mitsubishi Electric EZMotion-NC E60 Series, Operation Manual

Page: 338 / 510

9. Graphics
9.4 Use of the Check Modes
I -323
(3) Line types during checking
During tool nose
radius compensation
Not during tool nose
radius compensation
Manual feed — —
Program path Broken line (Cyan) Broken line (Cyan)
Rapid traverse
Tool center path Broken line (Cyan) Broken line (Cyan)
Program path Solid line (White) Solid line (White)
(Note2)
Cutting feed
Tool center path Solid line (Green) Solid line (Green)
(Note 1) The color indicated in parentheses in the table is used for a color display.
(Note 2) When both tool center path and program path are drawn, solid green line (which is used to
draw tool center path) is used.
(4) Switching graphic check trace
The path to be drawn can be switched by the parameters. These parameters will be valid
immediately after the settings.
Base specification
parameter
#1231 set03/bit2
Contents
0 Draw the path of both the machine coordinate value and tool position
coordinate value (tool nose point).
1 Draw only the path designated with the parameter #1231 set03/bit1.
Base specification
parameter
#1231 set03/bit1
Contents
0 Draw only the tool center path (machine coordinate value).
1 Draw only the program path (tool nose point).
(5) Counter display
The counter at the upper right corner and the drawing are switched as described in the table
below upon execution of "CHECK" or "STEP".
Screen status #1231 set03/bit1 Counter value to be displayed
0: Machine coordinate value Machine coordinate value
(calculated value) PROG.CHECK
MODE
1: Tool position coordinate value
*(Tool nose position in the
workpiece coordinate system)
Tool position coordinate value
(calculated value)
* When the screen is changed for the first time after turning the power ON, the screen status will be
the same as that during tracing. When the program check is completed or trace mode is canceled,
the previous counter display will be carried over.