Mitsubishi Electric EZMotion-NC E60 Series, Operation Manual

Page: 398 / 510

6. Operation Panel Switch Functions
6.16 Deceleration Check
II -37
(5) Deceleration check in movement including spindle/C-axis
When different values are set for the spindle/C-axis's position loop gain (when not cutting: spindle
parameter #3203PGC0); when cutting: spindle parameter #3330 PGC1 to #3333 PGC4) and the
servo axis's position loop gain, the deceleration check for the movement command of the axis
including the spindle/C-axis is as shown below.
Parameter
Rapid
traverse
command
Parameter
Other than rapid traverse
command
(G1:other than G0 command)
Inpos
(#1193)
G0
→
XX
(G0+G9
→
XX)
aux07/BIT-1
(#1223/BIT-1)
G1
→
G0
(G1+G9
→
XX)
G1
→
G1
0
Command
deceleration
check
0
1
In-position
check
1
In-position
check
(SV024 only)
No
deceleration
check
* In G1 feed, in-position check is carried out regardless of the deceleration parameter.
* XX expresses all commands.
(6) Deceleration check in polar coordinate interpolation/cylindrical interpolation start/cancel
command
•
The deceleration check in polar coordinate interpolation/cylindrical interpolation start/cancel
command block is as follows.
Parameter:#1223 aux07 BIT1 Deceleration check method
0 Command deceleration check
1 In-position check