3. Tool Offset (L system)
3.1 Wear Data
I
-79
Refer to "3 (II). Tool Offset (M system)" for M system.
(2) Menu selection method (#1136=1)
(a) Change over to the incremental value setting mode
Set value in #( ), X( ) or Z( ), then press
the + INPUT key.
[TOOL TIP OFFSET] TOOL 1.1/4
#I : INC.
#A : ABS.
#1
X 0.000
Z 0.000
2
X 0.000
Z 0.000
3
X 0.000
Z 19.700
:
:
:
:
:
:
T M
# ( 4 ) X ( ) Z ( )
[POSITION] X 123.456
Z
345.678
+INPUT
=INPUT
RETURN
(b) Change over to the absolute value setting mode
Set value in #( ), X( ) or Z( ), then press
the = INPUT key.
[TOOL TIP OFFSET] TOOL 1.1/4
#I : INC.
#A : ABS.
#1
X 0.000
Z 0.000
2
X 0.000
Z 0.000
3
X 0.000
Z 19.700
:
:
:
:
:
:
T M
# ( 4 ) X ( ) Z ( )
[POSITION] X 123.456
Z
345.678
+INPUT
=INPUT
RETURN
* When the cursor is moved to X( ) or Z( ) then the data key is pressed, =INPUT,+INPUT
menu will appear automatically.
(c) Supplement
• If INPUT key is pressed while = INPUT, + INPUT are displayed, the offset data can be set for
mode selection method.
• = INPUT, + INPUT are displayed until BACK menu key is pressed or other screens are selected.
The screen selection menu is displayed when TOOL OFFSET screen is selected again after
other screens are selected once.
•
"
↓
" Mark of the screen selection menu indicates that the operation menu exist on the screen
being displayed.
• The operation menu is invalid during the tool measurement with manual tool length
measurement function. The operation menu during the tool measurement operates as follows.
1) When the screen select menu is displayed
+ INPUT, = INPUT don’t appear during the tool measurement. If = INPUT, + INPUT with "
↓
"
mark are pressed during the tool measurement, ERROR (E74) will occur.
2) When the operation menu is displayed
If = INPUT, + INPUT are pressed during the tool measurement, ERROR (E74) will occur.
• = INPUT, + INPUT are invalid during the manual numerical command mode.
If = INPUT, + INPUT are pressed during the manual numerical command mode, ERROR (E74)
will occur. If the screen selection menu displayed with "
↓
" mark is pressed during the manual
numerical command mode, ERROR (E74) will occur.
• When the offset memory No. not displayed on the screen is set in setting area # ( ), the screen
corresponding to the offset memory No. set in will appear by pressing = INPUT,+ INPUT key of
one time. The offset data will be set by pressing = INPUT, + INPUT key again.
• When the tool nose point data is set on the NOSE-R screen, the absolute setting is selected
whichever of = INPUT and + INPUT key is pressed.
Summary of Contents for EZMotion-NC E60 Series
