Mitsubishi Electric EZMotion-NC E60 Series, Operation Manual

Page: 247 / 510

6. Data In/Out
6.2 DATA OUTPUT
I
-232
6.2.2 Outputting Tool Offset Data
Tool offset data and workpiece coordinate offset data which is set and displayed on the screen can be
output. The output operation can be made also during automatic operation.
(1) Tool offset data is output as follows:
Set the data type to tool data.
# ( 2 ) DATA ( )
# ( 2 ) DATA ( )
<OUTPUT DATA>
G10 L10 P···;
DATA OUT EXECUTION
# ( 2 ) DATA ( )
1) Data output is started. The contents of output
data and message "DATA OUT EXECUTION"
are displayed.
2) After the tape end code % (EOR) is output,
data output ends with message "DATA OUT
COMPLETE" displayed.
Press the
INPUT
key.
<OUTPUT DATA>
%
DATA OUT COMPLETE
# ( ) DATA ( )
(2)
Output tape format
Feed
Data area Feed Feed Feed
E E E E
O O G10L10P· · · O O
R B B R
The data area format is the same as tool offset input (G10) and work offset input (G10) by the
program.
The data is output in the order of the tool offset and workpiece coordinate offset data.