Mitsubishi Electric EZMotion-NC E60 Series, Operation Manual

Page: 490 / 510

Appendix 6. Operation Messages on Setting and Display Unit
IV -18
Appendix 6 Operation Messages on Setting and Display Unit
If a setting operation error occurs on any setting and display unit screen‚ the error No. EOO and a
message describing the details of the error will display in the line above the data setting area or the
menu display area.
∆
: Message requiring resetting and restarting
×
: Message requiring restarting after canceling error conditions
(The bold characters are the messages displayed on the screen.)
Error No. Error message Details
E01 SETTING ERROR
∆
• The setting data is incorrect. An alphabetic character was set
when only number can be set‚ etc.
• Data was input without setting number (#).
(Word editing)
• Even though no retrieval data was set, menu key [
↓
] or [
↑
] was
pressed.
• Even though no data is stored in edit buffers, menu key
"Replace" was pressed.
• One of the following characters was entered as the first character
of the retrieval data and edit buffers: 0 to 9, ". ", " " (space), "+",
"
−
", "=", "*", " [ ] ", and " " " ".
• When the incremental detection system was used, the parameter
(#0 absolute position setting) was set on the absolute position
setting screen.
• The data input for the standard parameter setting or during
execution of formatting is not "Y" or "N".
• A value outside the setting range was specified for #1043 lang.
• Even though no language data exists, its output and comparison
were attempted. Check the numbers (0253 and 0254) of the
language data to be output.
• When the machine manufacturer macro program memory area is
the SRAM area, the setup parameter #1060 SETUP was set to
"20".
• When the machine manufacturer macro program memory area is
the SRAM area, writing of the machine manufacturer macro
program was attempted on PROGRAM COPY screen.