3. Tool Offset (L system)
3.1 Wear Data
I
-78
Refer to "3 (II). Tool Offset (M system)" for M system.
3.1.3 Tool Wear and Tool Length Data Setting Mode (incremental/absolute)
There are two types of selection method in the absolute value setting or incremental value setting for
the tool offset data: the mode selection method and the menu selection method.
The required method is selected with the parameter #1136 optype.
Absolute
setting
(Old)
Incremental setting
(New)
(Example)
Incremental/absolute value setting
Setting Display
• Incremental value setting
# (2) ( - 0.1)
#2 X-100.100
• Absolute value setting
# (2) ( - 100.1)
#2 X-100.100
Display
#2 X -100.000
(1) Mode selection method (#1136=0)
(a) Change over to the incremental value setting mode
Set I in # ( ), then press the
INPUT
key.
# ( I) X ( ) Z ( )
[TOOL DATA]
#I:INC.
#A:ABS.
"#1: INC." is highlighted, and the mode becomes the
incremental value setting mode.
(b) Change over to the absolute value setting mode
Set A in # ( ), then press the
INPUT
key.
# ( A) X ( ) Z ( )
[TOOL DATA]
#I:INC.
#A:ABS.
"#A: ABS." is highlighted, and the mode becomes the
absolute value setting mode.
(Note)
The mode is held even if the screen is changed or the power is turned OFF.
Summary of Contents for EZMotion-NC E60 Series
