Mitsubishi Electric EZMotion-NC E60 Series, Operation Manual

Page: 65 / 510

2. Monitor
2.4 PROGRAM SEARCH
I -50
2.4.3 IC Card Search
Program search is carried out to execute a machining program from the IC card.
Before using the IC card, confirm that the file to be searched exists in the IC card.
Files that can be searched are in the ANSI text format, having the file name of "Program No. +
extension (.PRG)".
Mount the IC card. Then, select tape operation mode and execute the following search:
(1) Set the target program number in O ( ). Set "2" in TAPE ( ).
(2) Press the
INPUT
key.
(Example)
O ( 1 0 ) N ( ) - ( )COL.( )
TAPE( 2 )
O ( 10) N ( ) - ( ) COL.( ) TAPE( 2)
SEARCH EXECUTION
O ( 10) N ( ) - ( ) COL.( ) TAPE( 2)
[PROGURAM SEARCH] MONITOR 4. 1/4
O 10 N 0-0
<SUB> O 0 N 0-0
[PROGRAM FILE]
100
200
300
400
1234
[COLLATION BLOCK]
O
N -
SEARCH COMPLETE
O( ) N( )-( ) COL.( ) TAPE(2)
1) Start search and read the file set
to O No. from the IC card.
(The file "10.PRG" is applied in
the case shown on the right.)
2) When the specified program is
found, the search completion
message is displayed.
The target numbers are displayed
at O, located at the top of the
screen. The data of the target
block is displayed in the
machining program's display
area.
3) Change the operation mode to the
tape mode when operating.
Press the
INPUT
key.
(Note) Program Nos. that are stored in the NC memory are displayed in [PROGRAM FILE].
(Supplements)
(1) Search from the files having the extension ".PRG" in the IC card. File name excluding the
extension is the number indicating the program No. (O No.)
(2) If the NC is reset after search is completed, the unsearched status returns.
(3) If the specified block has not been found after the data to the EOR is read, the following
message is displayed: "E03 NB NOT FOUND"
(4) After IC CARD search is completed, "2" is retained in the setting field of TAPE ( ). Thus, the
value does not need to be set for each IC CARD search. Note that the setting of tape ( ) must
be changed for a search in other than the IC card.
(5) N (sequence) No. or B (block) No. cannot be specified in the IC card search. If specified, the
error "E03 NB NOT FOUND" occurs.
(6) Machining program in the IC card cannot be searched during emergency stop. If attempted,
an error occurs.