2. Monitor
2.6 PLC SWITCH
I
-68
2.6 PLC SWITCH
When the menu key
PLC-SW
is pressed, the PLC SWITCH screen is displayed.
The control signals for operation are assigned by using user PLC. The PLC-SWITCH screen enables
you to set each control signal to ON or OFF. (A maximum of 32 signals)
This screen is created with the user PLCs,
so each screen will differ. Refer to the
instruction manual issued by the machine
maker.
RESERCH
PLC-SW
COM-VAR LOC-VAR MENU
[PLC SWITCH]
PARAM
6. 1/2
#
1 AUTO RESTART
9
2 BLOCK DELETE
10 AUTO POWER OFF
3 MANUAL ABS
11
4 OPTIONAL STOP
12
5 HANDLE IT
13
6
14
7
15
8
16
#( )
2.6.1 PLC Switch ON and OFF Operation
Set the number of the switch to be set to ON in # ( ) and press the
INPUT
key. The mark of the switch
is set to the up position.
In this state, the switch function becomes effective and is controlled.
To set OPTIONAL STOP to ON.
Set 4 in # ( ).
Press the
INPUT
key.
RESERCH
PLC-SW
COM-VAR
LOC-VAR MENU
[PLC SWITCH]
PARAM
6. 1/2
#
1 AUTO RESTART
9
2 BLOCK DELETE
10 AUTO POWER OFF
3 MANUAL ABS
11
4
OPTIONAL STOP
12
5 HANDLE IT
13
6
14
7
15
8
16
#( )
The switch mark of OPTIONAL STOP is
set to the up position, indicating the
switch ON state.
To set the up-position switch (ON state) to OFF (down-position switch), set the number of the ON-
state switch in # ( ) and press the
INPUT
key.
The PLC switch names (message display) and the function to reverse selected message display are
prepared by using user PLC. These vary depending on the machine maker.
Summary of Contents for EZMotion-NC E60 Series
