4. Parameters (User)
4.1 Workpiece Coordinate
I
-140
Measure points B and C in the same
way, and set them.
6)
(Note) Width center workpiece offset
measurement is performed
when only points A and B are
set.
Perform the measurement by
one axis.
Point A
Point B
Point C
Set the setting number of workpiece
coordinate system, then press the
INPUT key.
#( 54 )( )( )( )
7)
The hole center is calculated from
points A, B and C.
The value that subtracted external
workpiece offset value from the
calculated hole center value is set.
The setting column highlight returns to
normal and the value is cleared to 0.
Return the sensor to the reference
point, and turn OFF the
measurement switch.
8)
The message " WLM " disappears.
(3) Width center workpiece offset measurement procedure
Perform an operation such as a
reference point return to position the
tool on the reference point.
1)
Turn ON the measurement switch on
the machine operation board.
2)
The message " WLM " appears.
Move the sensor into the groove
using manual feed and manual
handle feed.
3)
Summary of Contents for EZMotion-NC E60 Series
