Mitsubishi Electric EZMotion-NC E60 Series, Operation Manual

Page: 80 / 510

2. Monitor
2.5 Resuming the Program
I -65
2.5.4 Manual Numeric Commands with Program Restart
If restart search is completed, the M, S, T and B codes used for machining will appear on the second
page of the PROGRAM RESTART screen. The M, S, T and B functions can be set in the time
between the completion of the restart search and the resetting or start.
The maximum numbers of the codes that can be displayed are 35 for the M functions, 3 for the S
functions, 3 for the S2 functions, 3 for the T functions and 3 for the B functions. If these numbers of
codes used for the machining are exceeded, the codes used first are not displayed. The codes that
are not displayed cannot be commanded on this screen, and so manual numeric commands are
executed on the POSITION screen.
The 2nd miscellaneous function code can be changed by setting the parameters.
Even if the miscellaneous function M is designated in the same block, these will appear in the
commanded order.
Press the
INPUT
key.
T-SELECT T 10
S-SPEED S1 3000
S-SPEED S2
2nd AUX B
AUX
M 6 3 8
9 6
T-SELECT T 10
S-SPEED S1 3000
S-SPEED S2
2nd AUX B
AUX
M 6 3 8
9 6
1) The command value with the
cursor and the command name
display now change to a
highlighted display.
2) The highlighting remains and
the cursor does not appear
during the time until the
command has been executed.
3) Upon completion of the
command execution, the normal
display is resumed and the
cursor appears at the next
command value position.
4) The assigned codes are
displayed on the POSITION
screen.
Select page 2 of the PROGRAM
RESTART screen.
1) The M, S, T and B commands
used for machining appear.
2) The cursor blinks at the right end
of the data at the top left of the
screen.
Using the keys,
move the cursor to the position of the
data to be set.
T-SELECT T 10
S-SPEED S1 3000
S-SPEED S2
2nd AUX B
AUX M 6 3 8
9 6