Mitsubishi Electric EZMotion-NC E60 Series, Operation Manual

Page: 334 / 510

9. Graphics
9.4 Use of the Check Modes
I -319
9.4 Use of the Check Modes
To select a check mode, press menu key
CHECK
or
STEP
.
The check mode appears immediately when the check mode is selected.
(1) Preparation for checking
Press the menu key
SEARCH
to call the program.
O ( 1 0 0 0 )
N ( )
−
( )
Tape (0)
O ( ) N ( )
－
( ) TAPE (0)
Press the menu key
SEARCH
.
The data setting area appears.
Set the memory device for the program to
be graphically checked.
•
Memory operation
：
Tape(0)
•
Tape operation
：
Tape(1)
•
IC card operation
：
Tape(2)
(Example) To check O1000, proceed as follows:
Press
INPUT
key.
O 1000 N -
SEARCH COMPLETE
The setting area disappears.
A message appears to notify that the
search is completed.
O ( 1000) N ( )
－
( ) TAPE (0)
(Note 1) This operation search is exactly the same as that of the MONITOR function. Pressing the
automatic start button after the search is completed starts the automatic operation.
The operation mode is designated by the operation mode selection switch on the machine
operation panel.
In the IC card operation, checking is not possible by having the sequence No. and block No.
specified.
(Note 2) The first rapid traverse will not be displayed.