Mitsubishi Electric EZMotion-NC E60 Series, Operation Manual, Page: 78 / 510

2. Monitor
2.5 Resuming the Program
I -63
(3) Type 3 (T command restart) restart search
Press the
INPUT
key.
1) The block containing the T
command executed last will be
searched for.
2) The "RESEARCH EXECUTION"
message appears during the
search and upon its completion
the "RESEARCH COMPLETE"
message is displayed.
3) If even one axis is at a (–)
position from the value set in the
restart limit (#2072 rslimt), the
error "E98 CAN'T RESEARCH"
will occur. Manually return the
axis to a position where the
error will not occur, and then
search.
Set "3" in TYPE T ( ) in the setting
area.
O ( ) N ( ) - ( )
P ( ) T ( 3 ) M ( )
1) The data set in the setting areas
other than T ( ) and M ( ) will be
ignored.
2) Designate "1" in M ( ) for tape
search
M: MODE <0> MEMORY
<1> TAPE <2> IC CARD
T: TYPE <0> UNMODLE <1> TYPE 1 <2> TYPE 2
<3>T-TYP
O ( ) N ( ) - ( ) P
（ ）
T(3) M(0)
M: MODE <0> MEMORY
<1> TAPE <2> IC CARD
T: TYPE <0> UNMODLE <1> TYPE 1 <2> TYPE 2
<3>T-TYP RESEARCH EXECUTION
O ( ) N ( ) - ( ) P
（ ）
T(3) M(0)
[PROGRAM RESTART] MONITOR 5 .1/ 2
O 1000 N 5 - 0
<SUB> O N -
[RESTART- (G54)] [RESTART-R]
X -130.000 X -150.000
Y -10.000 Y -150.000
Z 0.000 Z 0.000
C 0.000 C 0.000
N51 Y-70.;
N52 X-20.;
M: MODE <0> MEMORY
<1> TAPE <2> IC CARD
T: TYPE <0> UNMODLE <1> TYPE 1 <2> TYPE 2
<3>T-TYP RESEARCH COMPLETE
O ( ) N ( ) - ( ) P
（ ）
T( ) M( )
(Note) Restart type 3 is valid only with the lathe system.