Mitsubishi Electric EZMotion-NC E60 Series, Operation Manual

Page: 238 / 510

6. Data In/Out
6.1 DATA INPUT
I
-223
6.1.4 Inputting Parameter Data
Parameter data which has been output by parameter output operation can be input.
The input parameter may go effective immediately after it is input or after the power is once turned
OFF/ON. (This is the same as when setting from the screen.) After data is input, turn OFF/ON the
power.
(Note) Parameter data input operation cannot be made during automatic operation.
(1) Inputting parameter data
Set the data type to parameter.
# ( 3 ) DATA ( )
# ( 3 ) DATA ( )
1) The parameter data input is started. The
contents of input data and message "DATA IN
EXECUTION" are displayed.
Press the
INPUT
key.
<INPUT DATA>
P5 N1 L···;
<COMP. DATA>
DATA IN EXECUTION
# ( 3 ) DATA ( )
<INPUT DATA>
%
<COMP. DATA>
DATA IN COMPLETE
# ( ) DATA ( )
2) When writing is completed, the message "DATA
IN COMPLETE" will display.
Turn the power OFF and ON once.
(2) Input parameter skip operations
1) Skipping N No. data not found in the specifications
When "S" is set in the second setting area during data input or compare, and the
INPUT
key is
pressed, an error will not occur even if parameter No. (N No.) data not found in the
specifications is input. Data input and compare of that number will be skipped.
(With normal input and compare, an error will occur if N No. data not found in the
specifications is input, and data input/compare will be stopped.)
2) Skipping axis data not found in the specifications
When "S" is set in the second setting area during data input or compare, and the
INPUT
key is
pressed, an error will not occur even if data with a different number of axes is input. Axis
parameters not found in the specifications will be skipped during the input and compare.
3) Skipping spindle data not found in the specifications
When "S" is set in the second setting area during data input or compare, and the
INPUT
key is
pressed, an error will not occur even if data with a different number of spindles is input.
Spindle parameters not found in the specifications will be skipped during the input and
compare.