Kyocera TASKalfa 550c, Manual

Page: 131 / 332

7.COMMAND CENTER ADMINISTRATOR MODE
Setting up From COMMAND CENTER 129
7 COMMAND CENTER ADMINISTRATOR MODE

Setting up SLP
When SLP is enabled, this equipment becomes a Service Agent that responds to requests from a User Agent for
searching particular services and registers services to a Directory Agent.
The SLP setting only supports print services shown below.
Raw TCP print, LPD print, IPP print, WSD print, SMB print, FTP print
About the "printer-location" attribute of SLP
SLP has an attribute called "printer-location" as one of the services provided. The information of "printer-location" is
the device setting information on the [General] submenu of the [Setup] menu on the [Administration] tab page, and that
of the [Location] field of [Device Information] on the [Device] tab page. If you have changed the setting of the [Location]
field on the [Device] tab page, turn the power of this equipment and then back ON, so that the "printer-location"
information of SLP will be overwritten with a new one.
1) Enable SLP
Select whether SLP service is enabled or disabled.
2) TTL
Set TTL (Time To Live, a scope in the network that provides SLP service). This is to enable the communication among
User Agents and Directory Agents located on different networks.
3) Scope
Set this for specifying the scope of groups that provide SLP services. The default value is "DEFAULT".

More than one group can be entered for [Scope] by separating them with a comma.

Characters ( ) \ ! < = > ~ ;

+ cannot be entered in this field.

Do not leave this field blank or the SLP setting will be disabled.
1
2
3