Kyocera TASKalfa 550c, Manual

Page: 129 / 332

7.COMMAND CENTER ADMINISTRATOR MODE
Setting up From COMMAND CENTER 127
7 COMMAND CENTER ADMINISTRATOR MODE
6) Account Name
Enter the account name for this equipment to access the POP3 server.
Enter the account name without the domain name when [NTLM/SPA] or [Kerberos] is selected in the
[Authentication] option.
7) Password
Enter the password for this equipment to access the POP3 server.
8) Scan Rate
Enter how often this equipment should access the POP3 server for new messages.
9) Port Number
Enter the port number to access the POP3 server. The port number depends on the port setting in the POP3 server.
Generally “110” is used.
10) SSL Port Number
Enter the port number to access the POP3 server using SSL. The SSL port number depends on the port setting in the
POP3 server. Generally “995” is used.
11) POP3 Client Connection Timeout(1-180)
Enter timeout period for quitting communication when no response is received from the POP3 server from 1 to 180
seconds.

Setting up SNTP Service
In SNTP Service, you can specify the SNTP server to refresh the time settings of this equipment using SNTP service.
1) Enable SNTP
Select whether the SNTP service is enabled or disabled. When this is enabled, the time settings of this equipment can
be adjusted using the SNTP service.
2) Primary SNTP Address
Specify the IP address of the primary SNTP server when the SNTP service is enabled.
3) Secondary SNTP Address
Specify the IP address of the secondary SNTP server as required.
When the [Obtain a SNTP Server Address automatically] option is enabled in the TCP/IP settings, the SNTP server
address can be obtained using the DHCP server.

P.109 “Setting up TCP/IP”
4) Scan Rate
Enter how often this equipment should access the SNTP server.
5) Port Number
Enter the port number for the SNTP service. Generally “580” is used for the SNTP port number.
1
2
3
4
5