Kyocera TASKalfa 550c, Manual

Page: 113 / 332

7.COMMAND CENTER ADMINISTRATOR MODE
Setting up From COMMAND CENTER 111
7 COMMAND CENTER ADMINISTRATOR MODE
9) IP Conflict Detect
Select [Enable] to display a message on the control panel when an IP address conflict is detected.
10) IP Address
Enter the static IP address that is assigned to this equipment when [Static IP] is selected in the [Address Mode] box.
11) Subnet mask
Enter the subnet mask if required when [Static IP] is selected in the [Address Mode] box.
12) Default Gateway
Enter the gateway address if required when [Static IP] is selected in the [Address Mode] box.

Setting up Filtering
You can set filtering in order to restrict access from client computers to this equipment. Filtering can be specified with an IP
address or a MAC address.
MAC address filtering is given priority over IP address filtering.
1) Enable IP Filtering
Select [Enable] for IP address filtering. When [Enable] is selected, access from devices on a network to which the IP
address (specified in [IP Filtering]) is set is restricted under conditions set in [IP Filtering Rule].
IP address filtering is enabled only under IPv4 network environment and it is disabled under IPv6 environment. If
you need to use IP address filtering under IPv6 environment, select MAC address filtering.
2) IP Filtering Rule
Select IP address filtering rules.
- Permit — Select this to permit access from devices on a network to which the IP address (specified in [IP Filtering])
is set.
- Deny — Select this to deny access from devices to which the specified IP address is set.
1
2
3
4
5
6