Fuji Electric ALPHA5 Smart, User Manual

Page: 625 / 636

CHAPTER 15 APPENDIXES
Replacement (from FALDIC-W)
15-33
15
 GYS motor (750 W)
The table below shows the cables and the connectors for the GYS motor of 750 W and the servo
amplifier.
Purchase Type
Motor power cable Existing item can be used. -
(1)
Motor power connector To be purchased. WSK-M03P-F
(2) Power supply connector To be purchased. WSK-S03P-F
(3) Sequence I/O cable Existing item can be used. -
(4) Encoder cable To be purchased. WSC-P06P □□ -E
(5) DC circuit connector Supplied with the amplifier. WSK-R05P-F
□□ : cable length
 Cable processing
(1) Motor power cable
Cut the motor power cable connector
part on the amplifier side, and then
connect it to the motor power connector
for ALPHA5 Smart.
(2) Power supply cable
Cut the power supply cable connector
part for FALDIC-W, and then connect it
to the power supply connector for
ALPHA5 Smart.
(3) Sequence I/O cable
If the wiring of pulse is used with an open collector, be sure to cut the no. 7 pin (CA) and no.20 pin (CB)
on the amplifier-side connector.
(4) Encoder cable
Purchase an encoder cable for ALPHA5 Smart. Or, exchange the amplifier-side connector of the
existing encoder cable. (Exchange connector type: WSK-P06P-M)
(5) DC circuit connector
If an external regenerative resistor is used, disconnect the short-circuit wire at 3-4 terminal (RB2-RB3
terminal) and connect it to the 2-3 terminal (RB1-RB2 terminal).
Connection with a GYS motor (750 W)
Cut here.
Cut here.
servo amplifier (Frame2)