Fuji Electric ALPHA5 Smart, User Manual

Page: 124 / 636

CHAPTER 2 WIRING
2-76
Description of I/O Signals
2
 Relevant description
For details, refer to "Edit permission."
Data error: Sequence output signal (Reference value 30)
The signal is turned on if the data reading or writing process does not proceed correctly.
 Function
The signal is turned on if the address and data are incorrect (drifting beyond the specification limit)
when performing teaching.
 Parameter setting
To assign the data error to a sequence output terminal, enter the corresponding value (“30”) to the
output terminal function setting parameter.
Address error: Sequence output signal (Reference value 31)
The signal is turned on when deviation from the positioning data number range and speed data range
(at start) is detected.

Function
The signal is turned on if the start positioning (“4”) signal is turned on while AD3 through AD0 are
turned off with PA2_41 (sequential start selection) being “0” (disable).
Start operation with a correct positioning data number to turn the signal off.
 Parameter setting
To assign the address error to a sequence output terminal, enter the corresponding value (“31”) to
the output terminal function setting parameter.
Alarm code 0: Sequence output signal (Reference value 32)
Alarm code 1: Sequence output signal (Reference value 33)
Alarm code 2: Sequence output signal (Reference value 34)
Alarm code 3: Sequence output signal (Reference value 35)
Alarm code 4: Sequence output signal (Reference value 36)
Upon alarm, signal to output alarm details into code
 Function
When an alarm occurs, the detected alarm detail can be specified by checking the signal of the
alarm code 0 to 4 assigned to OUT output signals.
 Parameter setting
To assign alarm code 0 to 4 to sequence output terminals, specify the corresponding value ("32" to
"36") to the output terminal function setting parameter.