EXFO FTB-1, User Manual

Page: 90 / 675

Selecting and Starting a Test
78
FTB-700G/800 Series
Ethernet Test Applications
Ethernet Test Applications
To select, configure, and start an Ethernet test:
1.
From the test menu, tap
Setup
.
2. From the Test Applications tab, under Ethernet , tap a test icon.
3. From the
Test Configurator
tab configure the interface structure and
its parameters.
3a. Tap the Modify Structure button to set the basic structure of the
test such as the interface/rate, connector, etc. (refer to Modify
Structure Button on page 97).
3b.
Tap the interface block to configure the interface parameters
(refer to page 87). Ensure that the link is up and the power level
(when supported) is present in the status bar before proceeding
to the next step (refer to
Status Bar on page 28).
Modify Structure
Protocol Block
Test Block
Clock Block
Interface Block
Physical
Interface Port