V3.5 14/08/19
UD0089
Page 487
This Document is uncontrolled unless over stamped "CONTROLLED DOCUMENT"
Acceptance Warning
The Acceptance Warning option when enabled activates a beacon (to be wired into the Immobilisor on
site) 30 seconds before the acceptance period expires.
iFob Per Person Single Acceptance
When this option is selected the driver of the Truck will only be asked to press the Acceptance button
once, even if they leave the truck and come back later. If another driver uses the truck then they will
have to press the Acceptance button.
Time-out Delay
You can configure a period of time (in minutes) in which the truck operator has to perform their pre-
operational checks.
Shock Sensor
Shock Sensor Threshold
Select this option if the Immobilisor is fitted with a Shock Sensor module. You can configure the
shock sensor's g-force threshold level at which the Immobilisor will record a shock and act upon it.
NOTE:
this option if the Immobilisor is NOT fitted with a Shock Sensor module otherwise
the Immobilisor will not program correctly.
Vehicle Category
Select the type of shock sensor that you wish to configure...
Original Shock Sensor
Category A (Forklift Mass between 200 -1300 Kg's)
Category B (Forklift Mass between 1300 -3400 Kg's)
Category C (Forklift Mass between 3400+ Kg's)
Action after Shock
Again, if the Immobilisor is fitted with a Shock Sensor module, you can configure what actions should
be taken after the Shock Sensor Threshold has been breached.