V3.5 14/08/19
UD0089
Page 488
This Document is uncontrolled unless over stamped "CONTROLLED DOCUMENT"
Active Alarm Relay
If this option is selected, the alarm relay will activate if an impact occurred. Immobilisor is fitted with
a relay that can activate a siren or flashing light if an impact occurs.
If the option is not selected the alarm relay will not active under any circumstances.
Deactivate the Vehicle
If the option is selected, the vehicle will deactivate x number of seconds after impact depending on
the deactivation delay set.
NOTE:
Immediate deactivation of a vehicle after and impact may be dangerous as an
operator may need to move the vehicle to avoid further injury; therefore a small delay is
recommended.
Reset via Service iFob Only
If this option is selected, the Immobilisor can only be reset after an impact by a supervisor using their
Service iFob even if the power to the vehicle or Immobilisor is cut.
If this option is not selected, the operator will be able to reset the vehicle by removing and re-
inserting their Vehicle iFob.
iFob per Person
Truck type
Select the type of truck between 1 and 56. Users can only operate the types of truck they are
authorised to by allocating access levels 101 to 156. For example if a truck type of 5 was
programmed, a user authorised to operate the truck would be given access level 105.
Truck Address
Select the truck address between 1 and 1023. Each truck should have its own unique address. The
address is used by Traka32 to report on the events that have occurred for that truck.
Enabled Access Control
Select this option if the Immobilisor is used for Access Control.
Select this option if the iFob does not remain in the receptor socket for operation of the device e.g.
where an iFob is "touched" to open a door. If enabled an event is recorded in the iFob before
activating the device, this prevents the user from removing the iFob too quickly and losing the event.
In this mode the standby LED is Solid Red so as there is as little time as possible before activation.
