V3.5 14/08/19
UD0089
Page 742
This Document is uncontrolled unless over stamped "CONTROLLED DOCUMENT"
6.
Using a 4mm Allen Key, remove the cover panel screws one at a time and remove the cover panels.
7.
Using a large flat bladed screwdriver, remove the screws from the receptor strip you wish to release the iFobs
from. Remove the strip, carefully disconnecting the receptor ribbon cable.
8.
Using a small flat blade screwdriver, you will be able to pull back the small solenoid blade that holds the iFob
in place and remove the iFob.
9.
Repeat steps 9 to 11 for each receptor strip you wish to remove the iFobs from.
10.
When you have released the iFobs you require, replace all the receptor strips, reconnecting the receptor
ribbon cable. Using a large flat bladed screwdriver secure the receptor strips in place with the fixings and
spacers removed earlier.
NOTE:
It is essential that the receptor strips are replaced in the same location from which they
were removed otherwise the system will not function correctly.
11.
Using a 4mm Allen Key, replace the cover panels one at a time. Once the cover panels have been replaced
then close the door (if fitted).
