V3.5 14/08/19
UD0089
Page 263
This Document is uncontrolled unless over stamped "CONTROLLED DOCUMENT"
IMPORTANT:
Once Auto Comms has been activated, you can select which systems are to be included in Auto Comms on
an individual basis. To include a system, tick Include In Auto Comms in the
you can also Nominate a PC to auto communicate only with the selected system.
Nominating a PC can help to prevent the potential problem of more than one copy of Traka32 trying to
communicate with the same system at the same time in which case one of them could fail with an error. If
Nominate a PC is left not ticked, then all copies of Traka32 will auto communicate with the system.
Enable Automatic Synchronisation of External Users
Checking this option will automatically upload any user records that have been altered via the Traka.Net
Post-Box software to the relevant systems.
Skip Communication with Cabinets that Updated Users Did Not Have Access to
Normally, when a User’s security is changed by the 3rd Party Link Stored Procedures, Traka32 will
communicate with ALL cabinets to make sure that the user does not exist in any cabinets to which they don’t
have access (regardless of whether they had access or not). Switching this option on suppresses this
behaviour and results in much faster cabinet updates where there are many cabinets and users generally
only have access to one or two cabinets.
Preserve the State of Auto-Comms Online Mode
Selecting this option will allow you un-select the default '
' options, close Traka32 and have them remain un-selected when you re-open Traka32.
Generate Online / Offline Events
Selecting this option when using
will enable the system to generate 'Online' and
'Offline' events. If this feature is enabled, when TAAS starts up events are generated showing that all
systems are offline and as each system has a successful communication an event is generated showing that
it is now online. If in the future a system fails to communicate successfully then the offline event will be
generated again.
User Upload Limit
When user records are being added or updated by any of the 3rd party links all the updated users get sent to
all the required cabinets the next time that the auto-comms fires. If there are hundreds of users that need
syncing to lots of systems this can take a very long time, therefore an option is available to limit the number
of users that get updated each time the auto-comms runs.
This limit is configured by adding a line into the [AutoComms] section of the T32Settings.ini file as follows:
[AutoComms]
SyncExternalUserLimit=100
The example above is configured to upload 100 users each time but this value can be changed to suit the
customers’ needs.