V3.5 14/08/19
UD0089
Page 677
This Document is uncontrolled unless over stamped "CONTROLLED DOCUMENT"
The requirement for a 2
nd
Wiegand format can apply if an organisation are using 2 different Wiegand formats
for their access control system, e.g 26 bit and 37 bit.
Support second card format (Wiegand only)
This box will be checked if the firmware has been configured to support a second Wiegand card
format.
The remaining options on this view are a copy of the Wiegand options listed under the Reader Type
section, please see above.
Options
Reader and/or PIN
If this option is available, there are four different ways a user can access a system depending on how you
configure a user. Please refer to the
Anti Pass back
This box will be checked if the firmware has the
System 1
Product Type
This field shows the related product type, for example, Key Control, Remote Key Box and Lockers etc.
System ID Number
The System ID Number can be altered from 1 to 255.
NOTE:
If you alter this setting you will need to alter the System ID Number within the
window otherwise the Traka32 software will not be able to communicate with the Traka
System if the ID’s do not match.
Comms Delay
Slide the Comms Delay control to alter the comms delay between 0 and 255. This value should not be
altered from 0 but is made available for bust RS485 network adjustment.
NOTE:
If you alter this setting you will need to alter the RS485 Delay within the
Comms window otherwise communication problems could occur.
System Title
Enter a System Title to represent the system you are adding for example Reception or Basement.
