V3.5 14/08/19
UD0089
Page 98
This Document is uncontrolled unless over stamped "CONTROLLED DOCUMENT"
6.
Telnet to the XPort, for example ‘telnet 10.0.1.78 9999’. From the main menu.
a.
Select option 6 Security
b.
Press the Enter key until you are prompted to the 'Enable Encryption (N) ?'
c.
Press (Y) then Enter key to enable encryption
NOTE:
You can change this to N to turn off encryption however Traka32 will require the ‘Encrypt
communications to AES256’ tick-box to be un-ticked before it will communicate.
d.
You will then be prompted to enter 'Key length in bits (0)'. Type in 256 then press the Enter key.
This will set the encryption to AES256.
e.
You will then be prompted 'Change Key (N) ?' Press (Y) then press the Enter key to change key.
f.
You will then be prompted to 'Enter Key:'.
g.
Type in the Encryption Key which was earlier entered into the Traka32 system settings.
**-**-**-**-**-**-**-**-**-**-**-**-**-**-**-**-**-**-**-**-**-**-**-**-**-**-**-**-**-
**-**-**
Notes:
i. You do not need to type the dashes, the XPort will put these in for you.
ii. The XPort is not case sensitive!
iii. The Encryption Key cannot be viewed or read from the XPort
h.
Press Enter twice more and you will be taken back to the Telnet main menu.
i.
Select option 9 Save and Exit to save the changes.
j.
Once configured, navigate back to Traka32 and test the communications by simply Setting the Date
& Time to ensure it communicates correctly. If there is a problem with your communication, be sure
you have followed the pervious steps correctly.
