V3.5 14/08/19
UD0089
Page 110
This Document is uncontrolled unless over stamped "CONTROLLED DOCUMENT"
7.
Switch on the GPRS module by powering on the 8bit/16bit control board. You will see the following text
appear in the HyperTerminal.
8.
Then quickly type +++ and then wait 1 second to enter 'Command Mode'. If successful, the Fastrack
Supreme should output 'OK'.
9.
Certain parameters need to be configured in order to connect to the GPRS network. These details will be
supplied with the Fixed IP Address SIM Card. To enter the APN, Username, Password and Port Number enter
the following information:
AT+GECONF=”<APN>”,”<USERNAME>”,”<PASSWORD>”,<PORT>[,<UART_BAUDRATE>]
10.
The baud rate will depend on the Control PCB e.g. 8bit 7MHz = 19,200, 16bit = 34,800 etc. The example
below shows the details provided with the Traka development SIM card:
E.g.: AT+GECONF=”wirelesslogic.co.uk”,”traka”,”traka”,4001,19200
TIP:
To find out what the current settings are, type AT+GECONF? and the Fastrack Supreme
should output the settings (See Below).