V3.5 14/08/19
UD0089
Page 436
This Document is uncontrolled unless over stamped "CONTROLLED DOCUMENT"
Fault Repaired: Selecting ‘Fault Repaired’ will highlight that the fault has been repaired but will not clear the
fault or remove it from the list. This can be useful to highlight that a repair has been carried out but has not
yet been approved or checked for clearing.
5.
Select either ‘Fault Cleared’ or ‘Fault Repaired’ and click Save & Close. If you selected ‘Fault Cleared’, Traka32
will communicate with the Traka System removing the fault from the iFob. The fault will also have
disappeared from the Outstanding Faults list.
Clearing Faults at the Traka System
NOTE:
To enable clearing faults at the Traka System the option for Fault Logging at the cabinet must first
be enabled in the firmware configuration. See the
In order for a user to clear a fault at the Traka System they must first have access level 200.
1.
When a user with Access Level 200 returns an iFob with a fault to the system a message will appear on the
LCD showing the current fault code(s) for a few seconds followed by a message asking them to enter a fault
code. This second message will have the existing fault code already displayed.
