V3.5 14/08/19
UD0089
Page 884
This Document is uncontrolled unless over stamped "CONTROLLED DOCUMENT"
Installing the 16bit Control PCB Panel
The 16bit Control Panel is the same size as the 8bit Control PCB and uses the same mounting points.
1.
Place the 16bit Control Panel on the 4 mounting points with the Keypad Connector at the top and the Speaker
at the bottom.
2.
Using the 4 mounting screws, affix the panel.
All new systems fitted with the 16bit Control PCB will also have the new Power Supply. The Old Power Supply can be
used with the new 16bit Control PCB. You do not need to upgrade the power supply but if it is required, follow these
steps.
Removing the old Power Supply (if required)
1.
Switch off the mains supply and disconnect the power supply from the mains.
2.
Disconnect the DC cable from the Control PCB if not already done.
3.
Carefully remove the 2 mounting nuts and washers retaining these for installing the new Power Supply.
4.
Carefully remove any Earth Leads that were attached to the Power Supply mounting points and retain these
for use with the new Power Supply.
Installing the new Power Supply (if required)
