Raritan PX3-4000 series, Руководство пользователя

Страница: 582 / 688

Appendix F: PX3 Phase I LCD Display
561
To display the unbalanced load and active power of a 3-phase
inlet:
1. Switch to the current reading of any inlet line.
2. Press the Up or Down button until "W" or "%" is displayed to the right
of the LCD display. Make sure NONE of the inlet's line number is
displayed at the bottom of the display.

Unbalanced load - % is displayed for the unbalanced current
value.

Active power - W is displayed for the power reading. W means
Watt.
Overcurrent Protector Information
The Overcurrent Protector mode is displayed as either "CB" or "FUSE"
on the LCD display, which varies according to the type of overcurrent
protector implemented on your PX. CB refers to the circuit breaker and
FUSE refers to the fuse.
Below illustrates an overcurrent protector's information.
Section Example information
The selected target is the second circuit breaker (CB 2).
This circuit breaker's current reading is 0 amps.
The word "CLOSE" indicates that the state of the
selected circuit breaker is closed.
The word "MASTER" indicates the PX is the master
device in a USB-cascading configuration. See
Cascading the PX via USB
(on page 28).
For a standalone PX, this word is NOT displayed.
The measurement unit is A (Amp), indicating that the
reading is the current.
To display the overcurrent protector information:
1. Press the MODE button until the word "CB" or "FUSE" is displayed.