Delta ASD-A3-0121, Руководство пользователя

Страница: 343 / 603

Parameters ASDA-A3
8-86
Revision December, 2017
8
P2.075 ■ E-Cam alignment - Alignment target position
Address: 0296H
0297H
Default: 0 Control mode: PR
Unit: Pulse unit of master axis Setting range: 0 to (P5.084 / P5.083) -1
Format: DEC Data size: 32-bit
Settings:
Set the alignment target position for E-Cam alignment (master axis pulse).
Note:
1. The E-Cam function is not supported by the model A3-L.
2. When the input value is within the setting range, but if changes in the value of P5.084 or P5.083 causes the value to
exceed the range, this parameter is automatically reset to 0.
P2.076 ■ E-Cam alignment - Control switch
Address: 0298H
0299H
Default: 0x0000 Control mode: PR
Unit: - Setting range: 0x0000 – 0x6FF7
Format: HEX Data size: 16-bit
Settings:
Y UZ X
X E-Cam alignment control UZ Alignment forward direction allowable
rate (0 – 100%)
Y Filter intensity (0 – F) - -

X: E-Cam alignment control
3 2 1 0
Bit
Bit Function Description
0
Enable
alignment
Set this bit to 0 to disable this function; set this bit to 1 to enable this
function.
If enabled, the E-Cam alignment correction is executed when
DI.ALGN is on.
1
Trigger PR
immediately
Set this bit to 1 to enable this function. When the E-Cam alignment is
executing, the correction is stored in the PR data location specified by
P2.073, which triggers the PR immediately.
Set this bit to 0 to disable this function. When the E-Cam alignment is
executing, it does not trigger PR immediately to compensate the
correction. You must use the PR (P5.088.BA) when E-Cam
disengages in order to execute it.
2
Position of
the mark
0: if the mark is on the master axis, the position of the mark is not
affected when aligning.
1: if the mark is on the slave axis, the position of the mark is affected
when aligning.
3 Reserved -