Delta ASD-A3-0121, Руководство пользователя

Страница: 287 / 603

Parameters ASDA-A3
8-30
Revision December, 2017
8
For example:
When U is set to 1 and Y is set to 1 (and filter width is therefore 0.2 μs), and when the high and low
duty width of the command pulse are both larger than 0.8 μs ( and filter width is 4 times 0.2 μs),
then the pulse command is not filtered out.
>0.8 μ s
>0.8 μ s
When the high or low duty width of the pulse is smaller than the filter width, then it is filtered out.
Filtered signal Filtered signal
0.8 μ s
<0.8 μ s
If this low level pulse width is shorter than 0.8 μ s,
it may be filtered, and thus two input pulses will
be regarded as one pulse. If this low level pulse
width is shorter than 0.2
μ s, it will be filtered.
Pulse input Pulse input
<0.8 μ s
0.8 μ s
If this first pulse width is shorter than 0.8 μ s,
it may be filtered, and thus two input pulses will
be regarded as one pulse. If this pulse width is
shorter than 0.2 μ s, it will be filtered.
If you use an 125 ns (4 Mpps) input pulse, set the filter value Y to 0 to disable the filter function.
Note: when the high-speed pulse specification of the signal is 4 Mpps and the value of the filter is 0, then the pulse is not
filtered.
P1.001 ● Input for control mode and control command
Address: 0102H
0103H
Default:
0x0000 (Model: A3-M , A3-L)
0x000B (Model: A3-F)
Control mode: All
Unit: P (pulse); S (rpm); T (N-M) Setting range: 0x0000 – 0x111F
Format: HEX Data size: 16-bit
Settings:
YX Z U
YX
Control mode
setting
Z Direction control U DIO value control