4-136
4-137
Chapter
4
OPERA
TION
11. "MANUAL" mode
11.7 Changing the display units
The units used to indicate the current position on the RPB screen can be switched to either
"pulses" and "mm". If hand data for the R-axis is selected (hand definition is made), then
"Tool coordinate" mode can also be used.
[Procedure]
1) Press
(UNITCHG) in "MANUAL" mode.
This switches the units used to indicate the current position in "MANUAL" mode.
2) Each time the key is pressed, the units displayed on the upper right of the RPB screen
are switched to "X" or "J" or "T". However, "T" (Tool coordinate mode) can be selected
only when hand data for the R-axis is selected (hand definition is made).
■
Switching the display units
"pulse" units (J)
"mm" units (X)
"mm" units (T)
Tool coordinate mode
* Selectable only when hand data for the
R-axis is selected.
• "mm" units (Cartesian coordinates)
Displays the current position with a number consisting of an integer and a decimal
fraction.
• "pulse" units (joint coordinates)
Displays the current position with an integer.
Robot manual movement with Jog keys differs depending on the currently selected display
units. For more details, refer to "11.1 Manual movement" in this chapter.
Summary of Contents for RCX222
