Ronde & Schwarz 1304.0004K03, User Manual

Page: 748 / 1071

Remote Commands
R&S
®
FPL1000
748 User Manual 1178.3370.02 ─ 11
LAY:CAT?
//Result : '1',1,'2',2,'3',3,'4',4
//Remove Spectrogram
LAY:WIND2:REM //Remove Marker Table window
LAY:REM '3'
//Replace Marker Peak List window by Marker Table
LAY:REPL '4',MTAB
//--------------- Querying all displayed windows ------------------
//Query the name and number of all displayed windows (from top left to bottom right)
LAY:CAT?
//Result : '1',1,'4',4
//--------------- Changing the size of individual windows -------------
//Move the splitter between the Frequency Sweep window and the Marker Table window
//to enlarge the spectrum display to 80% of the entire height.
LAY:SPL 1,4,80
10.8 Setting Basic Spectrum RF Measurement Parameters
Commands required for common spectrum RF measurements are described here.
● Defining the Frequency and Span .........................................................................748
● Configuring Bandwidth and Sweep Settings .........................................................758
● Configuring the Vertical Axis (Amplitude, Scaling) ................................................765
● Configuring Triggered and Gated Measurements .................................................771
● Configuring the Data Input and Output ................................................................. 778
● Zooming into the Display .......................................................................................802
● Configuring the Trace Display and Retrieving Trace Data .................................... 805
● Working with Markers ............................................................................................831
● Configuring Display Lines ..................................................................................... 891
● Defining Limit Checks ........................................................................................... 894
10.8.1 Defining the Frequency and Span
The commands required to configure the frequency and span settings in a remote envi-
ronment are described here. The tasks for manual operation are described in
Chap-
ter 6.4, "Frequency and Span Configuration" , on page 303.
● Defining the Frequency Range ............................................................................. 748
● Adjusting Settings Automatically ...........................................................................753
● Configuring Signal Tracking .................................................................................. 756
10.8.1.1 Defining the Frequency Range
The following commands are required to define the frequency range.
Setting Basic Spectrum RF Measurement Parameters