Ronde & Schwarz 1304.0004K03, User Manual

Page: 795 / 1071

Remote Commands
R&S
®
FPL1000
795 User Manual 1178.3370.02 ─ 11
[SENSe:]CORRection:TRANsducer:GENerate <Name>
This command uses the normalized measurement data to generate a transducer factor
with up to 1001 points. The trace data is converted to a transducer with unit dB and
stored in a file with the specified name and the suffix
.trd
under
C:\ProgramData\Rohde-Schwarz\ZNL-FPL\trd
. The frequency points are allo-
cated in equidistant steps between start and stop frequency.
The generated transducer factor can be further adapted using the commands descri-
bed in
Chapter 10.10.3, "Working with Transducers" , on page 955).
Parameters:
<Name> '<name>'
Example: CORR:TRAN:GEN 'MyGenerator'
Creates the transducer file
C:\r_s\instr\trd\MyGenerator.trd
.
Manual operation: See "Save as Trd Factor" on page 297
DISPlay[:WINDow<n>][:SUBWindow<w>]:TRACe<t>:Y[:SCALe]:RVALue <Value>
This command defines the reference value assigned to the reference position in the
specified window. Separate reference values are maintained for the various displays.
Suffix:
<n>
.
Window
<w> subwindow
<t> irrelevant
Parameters:
<Value> Default unit: DB
Example: DISP:TRAC:Y:RVAL 0
Sets the value assigned to the reference position to 0 Hz
Manual operation: See "Reference Value" on page 297
Power Sweep Commands
The following commands are required to configure a power sweep using an internal
tracking generator.
For an example of performing a power sweep remotely, see Chapter 10.6.3.2, "Pro-
gramming Example: Measuring Compression Points" , on page 625.
Useful commands for power sweeps described elsewhere:
●
OUTPut<up>[:STATe]
on page 790
●
DISPlay[:WINDow<n>]:TRACe<t>:Y[:SCALe]:RPOSition
on page 770
●
SOURce<si>:INTernal:FREQuency:OFFSet
on page 792
●
SOURce<si>:POWer[:LEVel][:IMMediate]:OFFSet
on page 791
●
[SENSe:]CORRection:METHod
on page 794
Setting Basic Spectrum RF Measurement Parameters