Ronde & Schwarz 1304.0004K03, User Manual

Page: 298 / 1071

The Spectrum Application (RF Measurements)
R&S
®
FPL1000
298 User Manual 1178.3370.02 ─ 11
The power sweep signal is currently only available in the Spectrum application, and
only if the optional Internal Generator R&S
FPL1-B9 is installed.
For details, see Chapter 6.3.3.1, "Basics on the Internal Generator" , on page 285.
Usage ..........................................................................................................................298
State ............................................................................................................................298
Level Offset ................................................................................................................. 299
PS Frequency ............................................................................................................. 299
Frequency Offset .........................................................................................................299
Level Start / Level Stop ............................................................................................... 299
Calibrate Transmission ................................................................................................299
Normalization state ..................................................................................................... 299
Usage
Determines the type of signal provided by the internal generator:
●
"Independent CW source" on page 285: constant frequency and power level
●
"Tracking generator" on page 286: constant power level, frequency follows ana-
lyzer frequency (only available for frequency sweeps in the Spectrum application)
●
"Power sweep" on page 286: constant frequency, linearly increasing power level
(only available in the Spectrum application)
Remote command:
SOURce<si>:FREQuency:COUPling[:STATe]
on page 792
SOURce<si>:POWer:MODE
on page 796
State
Enables or disables the internal generator. The generator signal is output at the GEN
Output
50
Ω
connector on the front panel.
Remote command:
OUTPut<up>[:STATe]
on page 790
Receiving Data Input and Providing Data Output