The Spectrum Application (RF Measurements)
R&S
®
FPL1000
425
User Manual 1178.3370.02 ─ 11
time (zero span), as well as constant level values. It is not possible to check automati-
cally whether the points are below or above the marked level values - use limit lines for
that task (see
Chapter 6.11.2.1, "Basics on Limit Lines"
Two different types of display lines are provided:
●
Two horizontal lines: "Horizontal Line 1" and "Horizontal Line 2".
These lines are continuous horizontal lines across the entire width of a diagram
and can be shifted up and down.
●
Four vertical lines: "Vertical Line 1" to "Vertical Line 4"
These lines are continuous vertical lines across the entire height of the diagram
and can be shifted left and right.
Lables
Each line is identified by one of the following abbreviations in the diagrams:
●
H1: "Horizontal Line 1"
●
H2: "Horizontal Line 2"
●
V1: "Vertical Line 1"
●
V2: "Vertical Line 2"
●
V3: "Vertical Line 3"
●
V4: "Vertical Line 4"
6.11.1.2
Display Line Settings
Access
: "Overview" > "Analysis" > "Lines" > "Display Lines"
Four vertical and two horizontal lines can be defined in the display.
Horizontal Line 1/ Horizontal Line 2
............................................................................ 426
Display and Limit Lines
