Ronde & Schwarz 1304.0004K03, User Manual

Page: 778 / 1071

Remote Commands
R&S
®
FPL1000
778 User Manual 1178.3370.02 ─ 11
Manual operation: See "Trigger Source" on page 339
See "External Trigger 1" on page 340
See "IF Power" on page 340
[SENSe:]SWEep:EGATe:TYPE <Type>
This command selects the way gated measurements are triggered.
Parameters:
<Type> LEVel
The trigger event for the gate to open is a particular power level.
After the gate signal has been detected, the gate remains open
until the signal disappears.
Note: If you perform gated measurements in combination with
the IF Power trigger, the R&S FPL1000 ignores the holding time
for frequency sweep, FFT sweep, zero span and I/Q mode mea-
surements.
EDGE
The trigger event for the gate to open is the detection of the sig-
nal edge.
After the gate signal has been detected, the gate remains open
until the gate length is over.
*RST:
EDGE
Example:
SWE:EGAT:TYPE EDGE
Manual operation: See "Gate Mode" on page 345
10.8.5 Configuring the Data Input and Output
The following commands are required to configure data input and output.
● RF Input ................................................................................................................ 778
● Working with Power Sensors ................................................................................ 781
● Internal Generator Commands ..............................................................................790
● Configuring the Outputs ........................................................................................ 798
10.8.5.1 RF Input
INPut<ip>:ATTenuation:PROTection:RESet
.......................................................................779
INPut<ip>:FILTer:SAW
....................................................................................................779
INPut<ip>:FILTer:YIG[:STATe]
..........................................................................................779
INPut<ip>:IMPedance
.....................................................................................................780
INPut<ip>:SELect
...........................................................................................................780
INPut<ip>:UPORt:STATe
.................................................................................................780
INPut<ip>:UPORt[:VALue]
...............................................................................................781
Setting Basic Spectrum RF Measurement Parameters