LSIS 6731001500, User Manual

Page: 254 / 659

241
Learning Advanced Features
Fire Mode Function Setting Details
Code Description
PRT-44 Fire Mode PW
Fire mode password is 3473.
A password must be created to enable Fire mode. PRT-45 (Fire Mode Sel)
can be modified only after the password is entered.
PRT-45 Fire Mode Sel
Sets the Fire Mode.
Setting Function
0 None Fire mode is not used.
1 Fire Mode Normal Fire mode
2 Test Mode Fire mode test mode
In Fire test mode, faults are normally processed.
Using Fire test mode does not increase the count
value at PRT-48 (Fire Mode Cnt).
PRT-46 Fire Mode Dir Sets the run direction for Fire mode operation.
PRT-47 Fire Mode Freq Sets the operation frequency for Fire mode.
PRT-48 Fire Mode Cnt
Counts the number of the Fire mode operations. The number increases
only when PRT-45 (Fire Mode Sel) is set to ‘Fire Mode’. The count increases
up to 99, then it does not increase any more.
•
If damper or lubrication operations are set for the inverter, Fire mode operation is performed after
the delay times set in the relevant operations.
•
Note that Fire mode operation voids the product warranty.
•
In Fire mode test mode, the inverter does not ignore the fault trips or perform a reset restart. All
the fault trips will be processed normally. Fire mode test mode does not increase the Fire mode
count (PRT-48).
•
When the Fire mode operation is complete, the inverter stops operating and is turned off.