LSIS 6731001500, User Manual

Page: 202 / 659

189
Learning Advanced Features
EPID Basic Operation Setting Details
Code Description
EPI-01 EPID1 Mode
Sets the EPID1 modes.
Setting Function
0 None EPID1 is not used.
1 Always On EPID1 operates at all times.
2 During Run Operates only when the inverter is running.
3 DI Dependent Operates when terminal input (EPID1 Run) is
on.
EPI-02 PID Output
Displays the existing output value for the EPID controller. The unit, gain,
and scale that were set in the EPID group are applied on the display.
EPI-03 EPID Ref Value
Displays the existing reference value set for the EPID controller. The unit,
gain, and scale that were set in the EPID group are applied on the
display.
EPI-04 EPID1 Fdb Value
Displays the existing feedback value set for the EPID controller. The unit,
gain, and scale that were set in the EPID group are applied on the
display.
EPI-05 EPID1 Err Value
Displays the difference between the existing reference and the feedback
(error value). The unit, gain, and scale that were set in the PID group are
applied on the display.
EPI1-06 EPID1 Ref Src
Selects the reference input for the EPID control. If the V1 terminal is set
to an EPID1 feedback source (EPID1 F/B Source), V1 cannot be set as the
EPID1 reference source (EPID1 Ref Source). To set V1 as a reference
source, change the feedback source.
Setting Function
0 Keypad Keypad
1 V1 -10-10 V input voltage terminal
3 V2 I2 analog input terminal [When analog
voltage/current input terminal selection switch
(SW2) at the terminal block is set to I (current),
input 0-20 mA current. If it is set to V (voltage),
input 0–10 V]
4 I2
5 Int. 485 RS-485 input terminal
7 FieldBus Communication command via a communication
option card
8 Pulse TI Pulse input terminal (0-32 kHz Pulse input)