LSIS 6731001500, User Manual

Page: 209 / 659

196
Learning Advanced Features
5.11 Lubrication Operation
During a lubrication operation, the inverter outputs the lubrication signal through one of the
output relays when the inverter receives a run command. The inverter does not start operating
until the time set at AP2-46 (Lub Op Time) has elapsed and the Lubrication signal is turned off.
Group Code Name LCD Display Parameter Setting Setting Range Unit
AP2 46
Lubrication
operation time
Lub Op Time 0.1–600.0 (sec)
OUT 31-35
Multi-function
relay 1–5
Relay 1–5
33 (Damper
Control)
- -
Lubrication Operation Setting Details
Code Description
AP2-46 Lub Op
Time Outputs the lubrication signal for a set time when the inverter run command is
turned on. The inverter starts operating when the set time has elapsed.
OUT-31–35 Relay
1–5 Sets one of the output relays (OUT-31–35) to ‘30 (Lubrication)’ to enable the
Lubrication function.
Note
•
The lubrication function can be used to delay inverter operations, depending on the working
environment, since the inverter waits for the time set at AP2-46 (Lub Op Time) each time a run
command is received.
•
Lubrication operation is one of the essential system features that are available in both HAND and
AUTO modes.