LSIS 6731001500, User Manual, Page: 101 / 659

88
Learning Basic Features
OFF mode.
•
If a fault trip occurs during an operation in the AUTO or HAND mode, the inverter can be
reset using the reset signal from the multi-function input terminal as well. In this case, the
inverter turns back on in AUTO mode after the fault trip is released.
Use caution when the inverter is set to operate in AUTO mode by commands over
communication, and if COM-96 (PowerOn Resume) is set to ‘yes’, as the motor will begin rotating
when the inverter starts up, without additional run commands.
4.2 Setting Frequency Reference
The H100 inverter provides several methods to setup and modify a frequency reference for an
operation. The keypad, analog inputs [for example voltage (V1, V2) and current (I2) signals], or RS-
485 (digital signals from higher-level controllers, such as PC or PLC) can be used.
Group Code Name LCD Display Parameter Setting Setting Range Unit
DRV 7
Frequency
reference source
Freq Ref Src
0 KeyPad-1
0–11 -
1 KeyPad-2
2 V1
4 V2
5 I2
6 Int 485
7 Field Bus
9 Pulse
10* V3
11 I3
* ‘10(V3)~11(I3)’ of DRV-07 are available when Extension IO option is equipped. Refer to
Extension IO option manual for more detailed information.