Holip HLP-A100 Series, Operating Manual

Page: 9 / 187

HLP-A100 Series Operating Manual
HLP-A100 Series
-
2
-
Danger
● Be sure to turn off the power supply before wiring.
● Mount the drive in the metal and other non-combustible materials
to avoid the risk of fire.
● Don’t install the drive in a space with explosive gas, otherwise,
they lead to explosion.
● R, S, T terminals are power input terminals, never mixed with
U.V.W terminals. Be sure that the wiring of the main circuit is
installed on the input side to control the start and stop. Generally
it is required to control it through terminal commands. Special
attention should be paid to its use in the case of the start and stop
more frequently places.
● Do not install any switch component like circuit breaker or
contactor at the output of the inverter. If any of such components
must be installed due process and other needs, it must be ensured
that the inverter has no output when the switch acts. In addition,
it is forbidden to install any capacitor for improvement of power
factor or any varistor against thunder at the output. Otherwise
it will cause malfunctions, tripping protection and damages of
components of the inverter.
● Please use an independent power supply for the inverter. Do avoid
using the common power supply with an electrical welder and
other equipment with strong disturbance. Otherwise it will cause
the drive to protect or even damage the drive.
● Motor overload protection is not included in the default settings. If
this function is desired, set C01.09 (motor thermal protection) to
date value ETR trip or date value ETR warning.
● Do not make any high voltage test with any component inside the
inverter. These semi-conductor parts are subject to the damage of
high voltage.
● The IC board of the inverter are susceptible to the effect and
damage of static electricity. Don’t touch the main circuit board.
● Installation, commissioning and maintenance must be performed
by qualified professional personnel.
● Don’t carry the front cover of the inverter directly when handling.
It should be handled with the base to prevent the front cover off
and avoid the dropping of the inverter, which may possibly cause
the injuries to people and the damages to the inverter.