Holip HLP-A100 Series, Operating Manual

Page: 129 / 187

HLP-A100 Series Operating Manual
HLP-A100 Series
-
122
-
*C14.55 Function Description Range Unit Default Setting
Output Filter 0~3 0
Option: [0] Off;
[1] Sine-wave filter;
[3] Sine-wave filter with feedback;
Function: Select desired output filter.
*C14.50 Function Description Range Unit Default Setting
RFI Filter Switch 0~2 1
*C14.51 Function Description Range Unit Default Setting
DC-LinkVoltage
Compensation
0~1 1
*C14.52 Function Description Range Unit Default Setting
Fan Control 0~8 0
Option: [0] Off, Only the power supply is IT mains system can select [0] Off.
In this mode, the linkage can be reduced.;
[1] On, To ensure the inverter meets EMC standards, select [1] On;
[2] Reserved;
Option: [0] Disable;
[1] Enable;
Function: This f unction ensures the output voltage is independent of any
voltage f luctuations in the DC link . Low torque ripple. In some
cases, this dynamic compensation may cause resonance problems in
DC link circuit and then this f unction should be disabled.
Option: [0] Auto run. The f an will run normally when the internal
temperature is between 40
℃
and 55
℃
; The fan will run in
low speed below 40
℃
; The fan will run in f ull speed above 55
℃
;
[4] Run in low temperature, the inverter will not report low
temperature alarm in this mode;
[5-8] Reserved;
C14.5* DC Voltage Compensation