Holip HLP-A100 Series, Operating Manual

Page: 5 / 187

HLP-A100 Series Operating Manual
HLP-A100 Series
6.7 Parameter Group 06: Analog In/Out 95
6.8 Parameter Group 07: Controller 103
6.9 Parameter Group 08: Comm. and Options 106
6.10 Parameter Group 13: Simple PLC 110
6.11 Parameter Group 14: Special Functions 118
6.12 Parameter Group 15: Drive Information 123
6.13 Parameter Group 16: Data Readouts 127
6.14 Parameter Group 25: App. Functions Cascade 136
6.15 Parameter Group 30: App. Functions Wobble 145
Chapter 7 Quick Application Guide 150
7.1 Motor Parameter Adaption 150
7.2 Using LCP to control the drive [HAND] 150
7.3 Using digital in terminals to control the drive [AUTO] 151
7.4 Set-up selection 151
7.5 Potentiometer reference 152
7.6 Connect two-wire transductor to terminal AI 152
7.7 Reference for pulse input 153
7.8 Multi-speed 153
7.9 Speed up/down 154
7.10 Pulse start/stop 155
7.11 Digital speed up/down 155
7.12 Configuration Mode 156
7.13 Simple PLC 158
7.13.1 Order Execution 158
7.13.2 Parallel Execution 160
Chapter 8 Accessory Specification
161
8.1 Braking Resistor 161
8.2 Remote Mounting Kit 162
Chapter 9 EMC
163
9.1 EMC–Correct Installation 163
Chapter 10 Warnings/Alarms and Fault Handling
164
10.1 Fault List 164
10.2 Fault Indication and Trouble Shooting 168
Chapter 11 Maintenance
170
11.1 Note 170
11.2 Storage and Transport 170
Chapter 12 Communication protocol 171
12.1 Format specification 171
12.2 Coil addressing 171
12.3 Read Coil Status 173
12.4 Read Holding Registers 174
12.5 Force Single Coil 175