Holip HLP-A100 Series, Operating Manual

Page: 68 / 187

HLP-A100 Series
HLP-A100 Series Operating Manual -
61
-
*C01.23 Function Description Range Unit Default Setting
Motor Frequency 20~400 Hz *
Function: Enter the rated motor frequency from the nameplate data.
Description of the choice: Default setting depends on the inverter size.
Attention: Changing this parameter affects motor nominal speed set in
C01.25.
*C01.24 Function Description Range Unit Default Setting
Motor Current Dep. motor data A *
Function: Enter motor current value from nameplate data.
Description of the choice: Factory settings depend on the unit size.
*C01.25 Function Description Range Unit Default Setting
Motor Norminal Speed 100~9999 RPM *
Function: Enter the motor nominal speed value from the nameplate data.
Description of the choice: Factory setting depends on the unit size.
Attention: If motor frequency has been changed in C01.23, Nominal
Motor Speed will be affected.
*C01.29 Function Description Range Unit Default Setting
Automatic Motor
Adaption (AMA)
0~2 0
Option: [0] Disabled;
[1] Enable complete AMA, run complete AMA which will take
up a longer time;
[2] Enable reduced AMA, if LC filter is used between the motor
and the frequency converter;
Description of the choice: AMA can be used to obtain accurate motor
parameters, optimizing control performance.
Attention: If LC filter is connected between motor and the frequency
converter, only reduced AMA can be carried out, and can’t test
the symmetry of the motor and whether there are phase losses
in the drive. For the best possible adaptation of the frequency
converter, it is recommended to run AMA on a cold motor. This
function is disabled when the motor is running.