HLP-A100 Series
HLP-A100 Series Operating Manual
-
77
-
C03.19 Function Description
Range
Unit
Default Setting
Save Speed Up/Down Value
0~2
0
Option: [0] No Function;
[1] Stop Save;
[2] Power Down Save;
Function: This parameter is used for setting whether to save the data changed
in the Up/Down f unction if the f requency stops or af ter it power
down.
C03.40 Function Description
Range
Unit
Default Setting
Ramp 1 Type
0~2
0
Option: [0] Linear: Motor ramp up to the preset f requency with constant
acceleration.
[2] S ramp: Motor ramp to the preset f requency with non-linear
acceleration.
Description of Choice: If Linear [1] is selected, the f requency may exceed the
preset setting during the acceleration; If S ramp [2] is selected, due
to smoother S curve, it will automatically adjust acceleration when
approaching to the preset f requency to avoid exceeding it.
C03.4* Ramp1
Ramp type and Ramp time
Attention: It is possible to switch acceleration and deceleration via digital
input terminals, see parameterC05.1* choice. The state of the digital
input terminal is shown in binary code; If the drive detects the
corresponding digital input terminals connected, then the bit is”1”, on
the contrary is”0”. The corresponding relationship between state of
the digital input terminals
、
binary code and the selected ramp type are
as follows:
Summary of Contents for HLP-A100 Series
Page 1: ......
Page 2: ...HLP A100 Series Operating Manual...
Page 3: ......
Page 7: ...HLP A100 Series Operating Manual HLP A100 Series 6...
