Holip HLP-A100 Series, Operating Manual

Page: 97 / 187

HLP-A100 Series Operating Manual
HLP-A100 Series
-
90
-
[26] Bus OK. Local bus communication is normal;
[28] Brake-No warning. Brake is active, and no warnings are present;
[29] Brake ready/No fault. Brake is ready for operation, and no fault
is present;
[30] Brake fault (IGBT) . Brake IGBT module fault is present;
[32] Mech. Brake Control. Enter mechanical brake control signal, see
C02.2*;
[36] Control word bit11, bit11 in control word controls relay;
[37] Control word bit12, bit12 in control word controls relay;
[40] Exceeding reference range. Reference outside the setting range
in C04.54 and C04.55 ;
[41] Below reference, low. Reference is lower than parameter settings
in C04.54;
[42] Above reference, high. Reference is higher than the parameter
settings in C04.55;
[51] Local ref. active;
[52] Remote ref. active;
[53] No alarm. Frequency converter is running normally, no alarm;
[54] Start command active;
[55] Running reverse. Drive runs in counter clockwise;
[56] Frequency converter in HAND mode;
[57] Frequency converter in AUTO mode;
[60] Comparator 0. Using a simple PLC, the results of comparator 0;
[61] Comparator 1, Using a simple PLC, the results of comparator 1;
[62] Comparator 2, Using a simple PLC, the results of comparator 2;
[63] Comparator 3, Using a simple PLC, the results of comparator 3;
[70] Logic Rule 0, Using a simple PLC, the results of logic rule 0;
[71] Logic Rule 1, Using a simple PLC, the results of logic rule 1;
[72] Logic Rule 2, Using a simple PLC, the results of logic rule 2;
[73] Logic Rule 3, Using a simple PLC, the results of logic rule 3;
[80] Sample PLC Digital Output 1. Only active for DO1/C05.30;
[81] Sample PLC Digital Output. Only active for DO2/C05.31;
[82] Sample PLC Relay 1. Only active for Relay 1/C05.40 [0];
[83] Sample PLC Relay 2. Only active for Relay 2/C05.40 [1];
[84] Sample PLC Digital Output 3, only active for DO3/C05.32;
[85] Sample PLC Digital Output 4, Only active for DO4/C05.33;
[90] Up to Wobble Limit, see C30*;
[91] Up to Wobble ref., see par. C30*;
[100] Start Pump 1, see C25*;
[101] Start Pump 2, see C25*;
[102] Below water level, low. See par. C25*;
[103] Above water level, high. See par. C25*;