Dell N1100-ON, Reference Manual

Page: 950 / 2332

Security Commands
950
Syntax
tacacs-server source-interface { loopback loopback-id | vlan vlan-id }
no tacacs-server source-interface
• loopback-id — Identifies the loopback interface.
• vlan-id — Identifies the VLAN.
Default Configuration
By default, the switch uses the assigned switch IP address as the source IP
address for TACACS packets. This is either the IP address assigned to the
VLAN from which the TACACS packet originates or a loopback interface IP
address.
Command Mode
Global Configuration
User Guidelines
The source interface must have an assigned IP address (either manually or via
another method such as DHCP). Loopback interfaces are not suppported on
the Dell EMC N1100-ON Series switches.
Command History
Introduced in version 6.3.0.1 firmware.
Example
console#conf
console(config)#interface vlan 1
console(config-if-vlan1)#ip address dhcp
console(config-if-vlan1)#exit
console(config)#tacacs-server source-interface vlan 1
tacacs-server timeout
Use the tacacs-server timeout command in Global Configuration mode to set
the interval during which a switch waits for a server host to reply. To restore
the default, use the no form of this command.